Difference between revisions of "Installation on Debian"

Revision as of 12:02, 4 February 2007

This guide is written against Debian Etch (4.0). This release includes kernel linux-image-vserver-686, so no manual patching is needed. Hence, Installation on Debian Etch is pretty easy and straightforward.

Packages installation

The packages required by Linux-VServer are:

• linux-image-vserver-686 - This is the actual kernel
• util-vserver - These are the utilities used to administer the guests
• vserver-debiantools - These are special Vserver tools for Debian, used to create and duplicate Debian guest systems.
• ssh - This is probably already installed, but just in case it isn't

All the packages you need can be obtained via

apt-get install linux-image-vserver-686 util-vserver vserver-debiantools ssh

so run this as root and reboot. To check out wherever everything went fine you may run

uname -r

and check that kernel version is something like 2.6.17-2-vserver-686. That's it. Now let's create a virtual machine.

Virtual machine creation

On a Debian system, creation of guests is done via the newvserver command. The syntax for this command is:

newvserver --vsroot /var/lib/vservers/ --hostname [Hostname] \
--domain [Domain] --ip [IP Address]/[CIDR Range] \
--dist etch --mirror [Debian Mirror] --interface [Net Interface]

(the backslashes at the end of the lines mean that it continues onto the next line. You may copy it as-is [with the backslashes], or put the whole command on one line [and exclude the backslashes], as is done below)

The command line arguments are:

• vsroot - This is where the files for the guests are kept. On a default installation, this will be at /var/lib/vservers. Alternatively, some people create a separate partition for their vservers.
• Hostname - The hostname of the system (eg. test1)
• Domain - The domain of the system. This is usually the same as the domain you chose for the host system (eg. dan-network.local. This doesn't need to be real, it's only used internally.)
• IP Address- The IP address for the guest system (eg. 10.1.1.7)
• CIDR Range - The CIDR Range for your local network. For a 10.x.x.x network, this is usually /8. For a 172.16.x.x network, this is usually /16. For a 192.168.x.x network, this is usually /24. If your network is subnetted, this will be different. When in doubt, choose /8 :)
• Dist - The distribution to use. For the purposes of this exercise, we use etch.
• Debian Mirror - The Debian mirror you use (when in doubt, choose ftp://ftp.debian.org/debian)
• Interface - Your network interface, if it's not eth0 (eg. eth1).

So, let's make a test server. The settings for our test guest are like so:

• Hostname: test1
• Domain: example.com
• IP Address: 10.1.1.7
• CIDR Range: /8
• Debian Mirror: http://ftp.au.debian.org/debian/
• Interface: eth1

newvserver --vsroot /var/lib/vservers/ --hostname test1 --domain example.com \
--ip 10.1.1.7/8 --dist etch --mirror http://ftp.au.debian.org/debian/ --interface eth1

Virtual machine operation

To start VM just created, run

vserver test1 start

To get into it, type

vserver test1 enter

Again, study man for more information.

References

• Linux-VServer HOWTO by Daniel15: http://howtoforge.com/linux_vserver_debian_etch